Double Slip Boat Docks

Posted: February 16th, 2010   |   Category: Featured Projects

Double Slip Boat Dock 1

All steel docks are fabricated at Boat Dock Works’ Gainesville location. Boat Dock Works has been fabricating and installing private and community docks since 1999 with many satisfied customers to validate their high reputation.IMG_3034ee

IMG_3034eee

IMG_3034eeee

IMG_0781

IMG_05211

IMG_04991

IMG_0991 - Copy

32' x 32' double slip dock with front and side entry slip. Upper deck with partial gables

This 32′ x 32′ all welded steel, double slip dock on Lake Lanier was constructed with a 20′ x 32′ Upper/Sun deck with partial gables. Decking consist of Brazilian Hardwood. Dock was installed with a Boat Lift and two Jet Ski Ports.

IMG_0543

This all welded steel dock is located on the main channel of Bald Ridge Creek on Lake Lakier. All welded steel docks are built heavy to withstand rough water conditions.

This all welded steel dock is located on the main channel of Bald Ridge Creek on Lake Lakier. All welded steel docks are built heavy to withstand rough water conditions.

Another fine dock constructed and installed by Boat Dock Works located on Lake Hartwell. This dock is all welded steel I-beam framed. Dock was installed with a boat lift, jet ski port, swim ladder, dock box, cleats and bumpers. Dock is decked in Brazilian hardwood and is accessible by a 4′ x 60′ arched gangway.

Another fine dock constructed and installed by Boat Dock Works located on Lake Hartwell. This dock is all welded steel I-beam framed. Dock was installed with a boat lift, jet ski port, swim ladder, dock box, cleats and bumpers. Dock is decked in Brazilian hardwood and is accessible by a 4' x 60' arched gangway.

 

 

Based on research, technical data, and years of experience using a variety of products manufactured for building docks and swim platforms, Boat Dock Works stands firm on our decision to use only the finest materials available for the construction of heavy-duty, rigid docks.

All materials are cut in custom jigs for precise fit. Any and all joints are beveled before being welded. Our quality steel frames consist of 12″ all welded bar joists, which are constructed of 2″ x 2″ x 1/8″ angle iron and 1/2″ x 1/2″ solid square bars. Double 2″ x 2″ x 3/16″ square tubing is used for upright construction. Roof joints usually consist of 2″ x 4″ or 2″ x 6″ structural rectangular tubing.

Custom picketed handrails and/or bench seats wrap the upper decks. Our in-house paint process consists of a complete acid wash, epoxy primer and two coats of gloss enamel automotive paint, entirely sprayed to provide the finest finish in the marine industry. Hot dipped galvanized finish is also available.

The entire steel frame is set on 10-year shoremaster encapsulated flotation, which is fastened by 1/4″ stainless bolts. Docks sit high (approximately 10″) and level. Roofing material is 26 gauge. All decking is screwed down and trimmed in bumper material. Anchoring includes 4″ steel anchor poles with wenches and/or shorelin anchor system. All cable and hardware is stainless. Hinges and high stress points are always double reinforced.

No comments for this entry yet...

Leave a Reply